Scope of application
LED light strips and LED light bars have been widely used in furniture, automobiles, advertising, lighting, ships, bars and other industries.
Installation method
①The width of the four-wire light strip is about 22mm, the thickness is about 8mm, and the weight is about 0.25kg/m (4 meters per kilogram)
②The four-wire light strip has four wires, three rows of lights (note that it is not four rows of lights~~), and 24 lights per row of 1 meter, 24*3=72. Because the power of each lamp bead is 0.05W, the power of the 72-bead light strip is: 72*0.05=3.6W.
③There is a "scissors" mark on each meter, which can only be cut at the mark. Cutting wrong or off-center will cause one meter to not light up! Some will be off-center when marking. It is best to look carefully at the position of the mark before cutting, and cut it according to the unconnected place in the middle. You can see it if you look carefully.
④Each light strip must be equipped with a special plug (plug with transformer); when connecting, be sure to remove the transparent plastic cover, and cover it after connecting the test light. Do not connect directly with the cover, which is easy to short-circuit.
⑤ When installing the light strip, it is usually placed in the light trough and straightened. It can also be fixed with a thin rope or thin wire. If you need to install it outside or vertically, you need to purchase a clip and a tail plug separately. The original clip is completely transparent. It is best to apply waterproof glass glue on the tail plug and the plug after installation, so that the waterproof performance is better.
The use of a special solder-free quick connector provides the possibility for personal installation at home, without the need for special tools such as soldering irons. Use as follows
Non-waterproof soft light strip quick connector instructions for use
Figure A1: Connector for connecting the power supply to the soft light strip.
Figure A2: Open a lock on one side of the product and fold the cover up.
Figure A3: After the folding cover is opened, insert one end of the soft light strip into the connector, and then fold the folding cover back and lock it.
Figure A4: Complete the connection.