LED Light Belt Maintenance Instructions

1. Anti-static: Since LED is an electrostatically sensitive component, if anti-static measures are not taken when repairing LED light strips, the LED will be burned out and cause losses. It should be noted that the soldering iron should use an anti-static soldering iron, and the maintenance personnel must also prepare anti-static measures (such as wearing an anti-static ring and anti-static gloves, etc.).
2. Continuous high temperature: The two main components of LED light strips are LED and FPC. If the FPC is continuously exposed to high temperature or exceeds its acceptable measurement, the FPC cover film will crack, indirectly causing the LED light strip to be scrapped. At the same time, LED cannot withstand high temperature continuously. If it is exposed to high temperature for a long time, its chip will be burned out by high temperature. Therefore, the soldering iron used to repair LED light strips is a temperature-controlled soldering iron, which limits the measurement within a certain range and prohibits arbitrary changes and settings. In addition, even so, it is necessary to pay attention to the fact that the soldering iron cannot stay on the LED pin for more than 10 seconds during maintenance. If it exceeds a certain time, it is very likely to burn the LED chip.
3. Short circuit: Many LED strips do not light up because there is a short circuit at the pin. Before repairing, you must find out the real reason for the failure. Otherwise, if you rashly replace the LED that does not light up, the LED chip will be broken down by the short-circuit DC when the power is turned on again. Therefore, in advance, you must first find the real reason for the failure to light up, so that you can get twice the result with half the effort.